In the operation of machining center, how to clamp the workpiece tightly? And that's where the jigs are used. Well, today I will summarize the fixtures that we often use in operation.
Chuck. The chuck can be said to be familiar with our robots, can not be in the familiar fixture. Chuck has a hundred years of history. Can be said to be a very classic fixture.
T-type table. T-type table can be said to be very classic, where there is a machining center, there is a T-type table.
T block, screw, press plate and nut. It is difficult to imagine how the workpiece would be clamped to the machine tool without these combinations.
Bench vice, mousse. If the pressure plate can not hold down the workpiece, it can be considered to use a bench vice or a Maxwell's fixture.
Magnetic platform. Magnetic platform is convenient, but relatively expensive.
Spindle and toolholder. The crystallization of human top wisdom and cutting-edge science and technology.
Spring jacket / cartridge. With it, a toolholder can realize different specifications of tool clamping.
Cylinder clamp. The essence of automatic fixture.
Dividing head. It used to be very beautiful. With the emergence of indexing spindle, it gradually declined.